The Export Monitor 2+ tool is located on the storage “Customer Tools CD” under the “Monitor2” directory. The ISO image can be downloaded from the Hitachi Vantara support site. Select the Hardware downloads and the correct micro-code level related to the storage system.
Download Page:
Instructions for installation are available within the “Monitor2” directory. Ensure JRE 11.0+ is installed to avoid handshake errors such as:
For detailed instructions on installing and using the Monitor2 tool, refer to the documentation link below:
To collect the performance export data, follow these steps:
1. Create an exclusive storage login user ID to run the exports to avoid conflicts with other sessions (e.g., username=export).
2. Download and install the Export Tool 2+ from the Customer Tools ISO of the microcode.
3. Reduce the number of Control Units (CU) to 32 or less (replace SS:EE with the start/end control units):
runWin.bat show cu -ip x.x.x.x -login username password |
runWin.bat remove cu -cu SS:EE -ip x.x.x.x -login username password |
4. With the reduced CU count, change to 1-minute sample intervals:
runWin.bat show interval -ip x.x.x.x -login username password |
runWin.bat set interval -interval 1 -ip x.x.x.x -login username password -q |
5. Wait/Test and then list the available data point date/timestamp range (export range needs accurate info):
runWin.bat show range -ip x.x.x.x -login username password |
6. Run the export request:
runWin.bat export data -ip x.x.x.x -login export export -range 202310310951:202310311056 -outpath ..\myexportdata -option clear |
WARNING: DO NOT RUN THE EXPORT TOOL WITH THE -NOCOMPRESS OPTION!
runWin.bat help |
Tags:
PageID: 185400