UNIX DLMgetras Utility
Note: The DLMgetras script is integrated into the UNIX Getconfig script so there is no need to run this script if you run Getconfig.
Hitachi provides a DLMgetras shell script that can be run when experiencing problems with HDLM. This script gathers various files and outputs them to a directory that you specify.
# /usr/DynamicLinkManager/bin/DLMgetras {directory-to-which-collectedinformation-is-output [-f file-that-defines-information-to-be-collected] | -h}
You can also use lower-case characters (dlmgetras) as follows:
# /usr/DynamicLinkManager/bin/dlmgetras {directory-to-which-collectedinformation-is-output [-f file-that-defines-information-to-be-collected] | -h}
Windows DLMgetras Utility
This utility is in the following locations:
HDLM-installation-folder\bin
and
drive-where-the-installation-DVD-has-been-inserted:\HDLM_Windows\DLMTools
##
Use this utility only in an environment where the version of the installed HDLM and the version on the DVD are the same.
Format
When executing the DLMgetras utility from the command prompt
DLMgetras {[folder-to-which-collected-information-is-output] [-eventlogtime yyyy/mm/dd | -eventlogsize {all | maximum-file-length}]| -h}
You can also use lower-case characters as follows:
dlmgetras {[folder-to-which-collected-information-is-output] [-eventlogtime yyyy/mm/dd | -eventlogsize {all | maximum-file-length}]| -h}
When executing the DLMgetras utility from the Windows Start menu From the Windows Start menu, choose Programs, Dynamic Link Manager, and then DLMgetras.
You can change the Windows-installation-destination-drive-name\hdlmtemp portion by changing the target in the DLMgetras properties.
Parameters
You can specify parameters for the DLMgetras utility only from the command prompt.
folder-to-which-collected-information-is-output
Upload data output to TUF :
Specify the output folder for the information that is to be collected by the DLMgetras utility.