Physical SVP (Windows 7 Enterprise) hardware description
The physical SVP with Windows 7 operating system is provided by Hitachi Vantara. The physical SVP is a 1U management server that attaches to each VSP disk controller (DKC). The following sections describe the front and rear panels of the Hitachi Vantara-supplied physical SVP, along with the physical, electrical, and environmental specifications.
SVP (Windows 7) front panel
The front panel of the physical SVP is equipped with LEDs, a reset button, and a power button.
|
Item |
Description |
| 1 |
LEDs. From left to right, the LEDs are:
|
| 2 |
Reset button. |
| 3 |
Power button. Applies power to or removes power from the SVP. |
SVP (Windows 7) rear panel
The only ports used at the rear panel of the physical SVP are the power socket and the four LAN ports. The following ports connect to your IP network, the management console PC, and the user LAN port on each storage system controller.
|
Item |
Description |
| 1 |
Power socket. Attach the power cable supplied with the SVP. |
| 2 |
Four LAN ports arranged as follows: LAN3 LAN4 LAN1 LAN2 These ports connect to your IP network, the management console PC, and the user LAN port on each storage system controller. |
After the Initial Startup Wizard is run, the SVP can be used in non-bridge mode. In this mode, the cables can be removed from SVP ports LAN3 and LAN4 and attached to switches. For more information, contact customer support.
Service processor (Windows 7) hardware specifications
The following table lists the hardware specifications for the service processor (SVP) provided by Hitachi Vantara.
|
Item |
Specification |
|
Dimensions |
Height: 1.7 inches (43 mm) Width: 17.2 inches (437 mm) Depth: 14.5 inches (369 mm) Weight: 14 lbs (6.4 kg) |
|
Processor |
Celeron G1820 2.7-GHz 2M, 2C, 2T
|
|
Memory |
8-GB RAM DDR3 |
|
Hard drive |
2 TB |
|
Network interface card |
x4 ports (on-board NIC) + x1 IPMI (BMC) port |
|
Fans |
2 x 4-cm 4-pin PWM fans |
|
Operating system |
Windows Embedded Standard 7 |
Physical SVP (Windows 7) electrical specifications
The following table lists the electrical specifications for the physical SVP supplied by Hitachi Vantara.
|
Item |
Specification |
|
Rated AC voltage |
100-240 V, 50-60 Hz, 4.2 - 1.8A |
|
Power supply |
350 W AC power supply with PFC |
|
AC voltage |
100-240 V, 50-60 Hz, 4.2 - 1.8 Amp |
|
Power supply safety / EMC |
|
|
MFT p-code |
Description |
watts |
|
MBD-X10SLM+-LN4F-O |
Single-socket H3 (LGA 1150) / 32-GB DDR3 ECC 1600 MHz / 6x SATA / 4x GbE |
20 W |
|
CSE-512F-350B |
Two 350 W 3.5-inch internal drive bays |
26.4 W |
|
CM8064601483405 |
Intel Celeron G1820 2.7 Ghz 2M tray |
53 W |
|
0F11000 |
3.5-inch 25.4 mm 2 TB 32 MB 7200 RPM |
9.1 W |
|
KVR16E11S8 |
4 GB 1600 Mhz DIMM SR x8 with TS Kingston F |
4.05 W |
|
Total |
112.55 W | |
VA is 140.69, with a 0.8 power factor.
Physical SVP (Windows 7) environmental specifications
The following table lists the environmental specifications for the physical SVP supplied by Hitachi Vantara.
|
Item |
Specification |
|
Operating temperature |
41°F ~ 95°F (5°C ~ 35°C) |
|
Non-operating temperature range |
-40°F ~ 140°F (-40°C ~ 60°C) |
|
Operating relative humidity range |
8% ~ 90% (non-condensing) |
|
Non-operating relative humidity range |
5% - 95% (non-condensing) |