Viewing IP routes
To view the existing IP routes, navigate to .
The following table describes the fields on this page:
| Field / Item | Description |
| Cluster Node Routing | When this option is disabled (default behavior), the configured routes are propagated to all nodes in a cluster. If this option is enabled, it is possible to configure different routes for each node in a cluster.
CautionIf an EVS fails over to a node that is missing a required route, network traffic can no longer reach the required destination.
|
| Destination | For a Network route, this field displays the IP address and Address Prefix Length of the destination. For a Host route, this field displays an IP address only. |
| Gateway | This field displays the gateway IP address of the route. |
| Type | This field displays the type of route, which can be Host, Network, or Gateway. |
| Creation Type | A route is either static or dynamic. Static indicates a manually created route and dynamic indicates a route created by a switch. |
| MTU | This is the Maximum Transmission Unit which is the largest size Ethernet frame that the server can send for the route. |
NoteFields that are not required for a route type are grayed out and cannot be configured.