Recovering from power standby
When the server is in a power standby state, the power supplies are powered and the PSU LEDs are lit, but the Power Status LED on the rear panel is not lit.
The server will enter a standby power state due to any the following:
- The shutdown --ship --powerdown command has been issued.
- The PWR button was pressed when the server is running.
- The server has shut down automatically due to an over temperature condition.
You can restore the server to its normal power state by either of the following methods:
- Pressing the PWR button.
- Remove the power cables from both PSUs, wait for 10 seconds, then reconnect the cables to the PSUs.